AN510 REV 7
NOTES.
1. All dimensions are in inches, unless otherwise specified.
2. Interpret dimensions and tolerances in accordance with ASME Y14.5M.
3. Screws shall be free of all loose hanging burrs or slivers which may become dislodged
during usage.
4. Do no use unassigned dash numbers or codes.
5. In case of conflict the requirements specified herein shall take precedence over the
requirements specified in FF-S-92. For dimensions and tolerances not specified herein or
FF-S-92, refer to ASME B18.6.3.
6. These screws are not to be used in the construction of airframes or to attach equipment to
the airframe.
7. Slotted head screws are inactive for new design after 17 FEB 59. AN510 is superseded in
part by NASM35191, NASM35199, NASM35203 AND MS51960.
8. Changes from previous issue. Marginal notations are not used in this revision to identify
changes with respect to the previous issue due to the extent of the changes.
Custodians:
Preparing Activity:
Army - AV
DLA -IS
Navy - AS
Air Force - 99
(Project 5305-2011-005)
Review activity:
Army - MI
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business